Club323F
http://www.club323f.com/forum/

Hi all - new member - Q on replacing rear hatch/screen on BA
http://www.club323f.com/forum/viewtopic.php?f=67&t=60452		 Page 1 of 1
Author:  MarkSYD [ Fri Aug 04, 2017 8:15 am ]
Post subject:  Hi all - new member - Q on replacing rear hatch/screen on BA
Hi all, greetings from Sydney.

Does anyone know how to remove + replace the rear windscreen on a BA hatchback? And then reconnect the screen's heater element?

Or: If I replace the entire hatchback, how to remove and re-feed the electric cables into the replacement?
I have a complete spare hatchback - but the cabling was cut nearer to the hatch, than to the roof - so I expect that connecting the cabling will be difficult!

MANY THANKS in advance!
Author:  Lerch [ Fri Aug 04, 2017 8:44 am ]
Post subject:  Re: Hi all - new member - Q on replacing rear hatch/screen o
Welcome to the forum. I think I've seen this done before so have a search through :thumbleft:
Author:  MarkSYD [ Fri Aug 04, 2017 8:54 am ]
Post subject:  Hi all - new member - Q on replacing rear hatch/screen on BA
Many thanks Lerch! Much appreciated!
Author:  pitrack_1 [ Fri Aug 04, 2017 2:23 pm ]
Post subject:  Re: Hi all - new member - Q on replacing rear hatch/screen o
Hi MarkSYD, greetings from Castle Hill!

Well actually Canberra, the car's in Castle Hill. :)

It looks like you can replace the window if you wish, see the following threads/posts (unfortunately the pics have gone AWOL):
Post 1
Post 2

Alternatively you could have a look under the trim on the rear hatch- it may be that the hatch has its own wiring loom and there are connectors for the car's loom just inside the top panel of the hatch- apparently there's a connector there for the high mount rear stop LED/light. If this is the case you can simply unplug your car's loom swap the hatch over and reconnect the car and hatch looms.

Good luck, let us know how it goes,

Patrick
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/