Maybe your exhaust manifold isn't torqued properly?
| Club323F http://www.club323f.com/forum/ |
|
| Head Torque setting http://www.club323f.com/forum/viewtopic.php?f=53&t=40588 |
Page 1 of 1 |
| Author: | Codge [ Wed Jul 14, 2010 1:03 pm ] |
| Post subject: | Head Torque setting |
Hey guys need a bit of help. Replaced the head gasket on a 1993 323F LX. I followed the torque settings on the gasket case but need to give it a second tightening. Don't have a haynes manual so need torque settings. Torqued to 58 pounds at the moment but think thats too loose as she's sounded slighty louder than normal. Valve clearances would be great as well. Thanks in advance! |
|
| Author: | shanebrk [ Wed Jul 14, 2010 1:13 pm ] |
| Post subject: | |
|
Maybe your exhaust manifold isn't torqued properly? |
|
| Author: | Codge [ Wed Jul 14, 2010 3:21 pm ] |
| Post subject: | |
Cheers for that. Heard that on them you have to tighten 90 degrees loosen 5 and then tighten another 90. This would bring it 175 degrees beyond the 58 ft-lb. Do you know is this correct? |
|
| Author: | floridamary4 [ Sat Jul 31, 2010 10:49 am ] |
| Post subject: | re: |
thanks for the input it works out |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|