| Club323F http://www.club323f.com/forum/ |
|
| quick one http://www.club323f.com/forum/viewtopic.php?f=46&t=32281 |
Page 1 of 1 |
| Author: | margi [ Sun Apr 26, 2009 11:00 am ] |
| Post subject: | quick one |
i prob covering old ground for which im sorry but i was wondering if a turbo kit for a mazda 626 and mx6 will fit on my v6 323? many thanks |
|
| Author: | ph3n1x [ Tue Apr 28, 2009 9:56 am ] |
| Post subject: | |
Well, the manifold only fits the engine it is designed for. If the 626 has a somewhat different engine, it will not fit. If it fits, then you need the space to mount the turbo. Where the 626 is bigger than the 323f, this could be a problem too. Same thing for the intercooler. All the piping needs to be done right, yet again a size problem, so probably going to be a custom set of piping. So to make i short, make sure that you use the same engine, exactly the same! Have a good look at the pictures where they fitted the turbo setup, and spot the differances between the 323f and the 626 in space. Try to have a workaround for it. See how the did the intercooler, this is one hell of a job to get done right. So there is a lot to look at. Also have a look at the other turbo 323f, and read how they did their stuff and wich the problems were they ran into. |
|
| Author: | RHRH [ Tue Apr 28, 2009 11:57 am ] |
| Post subject: | |
With the V6 its easier to do a supercharger, but it wont fit properly under the bonnet. |
|
| Author: | margi [ Thu May 21, 2009 9:21 pm ] |
| Post subject: | |
[quote="RHRH"]With the V6 its easier to do a supercharger, but it wont fit properly under the bonnet.[/quote] guessin i would need a hence hole in bonnet for it and only drive it in dry weather? sounds a plan tho  ill be looking in to this in greater detail in the coming weeks
just off topic a lil can the old mark or new mark turbos fit the v6 ba? |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|