i prob covering old ground for which im sorry but i was wondering if a turbo kit for a mazda 626 and mx6 will fit on my v6 323?

many thanks

Well, the manifold only fits the engine it is designed for. If the 626 has a somewhat different engine, it will not fit.
If it fits, then you need the space to mount the turbo. Where the 626 is bigger than the 323f, this could be a problem too.
Same thing for the intercooler. All the piping needs to be done right, yet again a size problem, so probably going to be a custom set of piping.

So to make i short, make sure that you use the same engine, exactly the same! Have a good look at the pictures where they fitted the turbo setup, and spot the differances between the 323f and the 626 in space. Try to have a workaround for it.
See how the did the intercooler, this is one hell of a job to get done right.
So there is a lot to look at.
Also have a look at the other turbo 323f, and read how they did their stuff and wich the problems were they ran into.

With the V6 its easier to do a supercharger, but it
wont fit properly under the bonnet.

[quote="RHRH"]With the V6 its easier to do a supercharger, but it
wont fit properly under the bonnet.[/quote]

guessin i would need a hence hole in bonnet for it and only drive it in dry weather?

sounds a plan tho ill be looking in to this in greater detail in the coming weeks

just off topic a lil

can the old mark or new mark turbos fit the v6 ba?