i no what i need to do conect ten and ground to geva in the dianostic port then fiddle with the screw, i just need a picture of the dicnostic port with the numbers on so i dont connect the wrong 1's if any 1 could help would me mutch apreached
| Club323F http://www.club323f.com/forum/ |
|
| Poor idleing 1.5 1998 http://www.club323f.com/forum/viewtopic.php?f=19&t=43087 |
Page 1 of 1 |
| Author: | chris_speed [ Sun Dec 12, 2010 2:35 pm ] |
| Post subject: | Poor idleing 1.5 1998 |
i no what i need to do conect ten and ground to geva in the dianostic port then fiddle with the screw, i just need a picture of the dicnostic port with the numbers on so i dont connect the wrong 1's if any 1 could help would me mutch apreached
|
|
| Author: | Stuz [ Tue Dec 14, 2010 12:35 am ] |
| Post subject: | Re: Poor idleing 1.5 1998 |
have you cleaned your maf ? |
|
| Author: | chris_speed [ Tue Dec 14, 2010 3:55 pm ] |
| Post subject: | Re: Poor idleing 1.5 1998 |
ive not will this help?? |
|
| Author: | Simondo [ Tue Dec 14, 2010 5:17 pm ] |
| Post subject: | Re: Poor idleing 1.5 1998 |
Won't do any harm. Unless you break it. Then you're buggered! 
|
|
| Author: | shinar [ Sun Dec 19, 2010 7:39 pm ] |
| Post subject: | Re: Poor idleing 1.5 1998 |
What is the procedure for cleaning the MAF? |
|
| Author: | Stuz [ Sun Dec 19, 2010 8:38 pm ] |
| Post subject: | Re: Poor idleing 1.5 1998 |
Buy a can of carb cleaner from haldords / fps/ and motor factors. 1. On the intake side of your engine remove the big bulky looking piece of plastic with the wires going to it. 2. Spray carb cleaner through it making sure you get the small thin piece of wire running trough the middle, DO NOT touch this as you will break it. 3. Spray the other parts of the intake system ( throttle body etc) 4. Replace and take the car for a drive and see if it's any better. This should cost no more that £6 and take less than 20 mins. Stu |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|