I am in the process of making the two original clear back lights that i have into reverse and fog lights, i have two spare ones, a clear and a red, which will have to be buchered to do it, the plan is to cut off the top part, just where the bulb holder fits on all four of the lights, these will be used again, then cut away a larger section off the back of the lights, large enough to house two bulbs, i will then get a piece of aluminium to make a small plate to cover the back of the lights where it has been cut away, cut two holes in the plate, about 30mm, then bond the bulb holder parts that were cut off before over these holes, cut another piece of aluminium to fit inside the light to seperate the reverse light from the fog light, then fit the aluminium plate with the bulb holders onto the back of the light, i will now have a reverse and fog light in each housing
will try and post some picys of the process.
Thanks Col. How did you find that link?
