Does anyone know how to replace the motor for the aerial on a V6
mine wont go up and down any more.
I can still here the a thunk when the power is switched on or off but thats all
the aerial itself doesnt move
anyone know how to fix this?
TFL
| Club323F http://www.club323f.com/forum/ |
|
| aerial http://www.club323f.com/forum/viewtopic.php?f=18&t=2355 |
Page 1 of 1 |
| Author: | TFL [ Thu Feb 10, 2005 6:27 pm ] |
| Post subject: | aerial |
Does anyone know how to replace the motor for the aerial on a V6 mine wont go up and down any more. I can still here the a thunk when the power is switched on or off but thats all the aerial itself doesnt move
anyone know how to fix this? TFL |
|
| Author: | GOGOBROOM [ Thu Feb 10, 2005 6:58 pm ] |
| Post subject: | |
Do a search on the Search facility.. this has been discussed quitre a few times in past :P if ya get stuck holla |
|
| Author: | JohnLi [ Thu Feb 17, 2005 5:57 pm ] |
| Post subject: | |
I changed mine for a Maplin one, which cost £20. Check out how much a Mazda one is though. The Maplin one is slightly different and you have to cut and connect the power leads as well as re-use some of your old fittings. My 323 is an exec on a R plate, after the face lift as well, don't know if they changed the arial at the face lift. link to fairly comprehnsive instructions are at http://www.club323f.com/club323f/forum/ ... hp4?t=1012 my post is quite far down. Hope this helps Ian. |
|
| Author: | parvez [ Mon Sep 19, 2005 4:26 pm ] |
| Post subject: | |
does the link on the post above work for anyone? |
|
| Author: | JAM [ Mon Sep 19, 2005 4:30 pm ] |
| Post subject: | |
No, It says the page cannot be found............. 
|
|
| Author: | ZerweX [ Mon Sep 19, 2005 5:07 pm ] |
| Post subject: | |
remove the "4" after php.. [url]http://www.club323f.com/club323f/forum/viewtopic.php?t=1012[/url] |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|